mendez4047

So, I finaly was able to pull the engine and I have to say, its a good experience. I had one problem, as I was hoisting the engine up, I did not notice the low oil sensor was still attached to the wiring harness/engine and snapped! is there a way to fix this without buying the harness or do I have to buy the whole thing? Is there a specific name for this harness?

<a href="http://s69.photobucket.com/albums/i70/mendez4047/?action=view&current=engine2.jpg" target="_blank"><img src="http://i69.photobucket.com/albums/i70/mendez4047/engine2.jpg" border="0" alt="Photobucket"></a>

mendez4047

motorman524

Soder, shrink wrap, and a torch.

mendez4047

AdderMk2

well that was dumb... lol

your best bet it to hit up a junkyard and pop the plug out of a pan, cut the wire back a few inches, and hook it into your harness

projectresto83

^^^ +1, just splice in another one.

Tony71502

BTW that is the low oil sensor.

mjr46

you can fix that, there is enough sticking out, all you have to do is get a pin release tool to dissassemble the connector and solder a new piece of wire to remaining pig tail and reassemble connector, done it tons of times