car wont start when hot im lost. plaese help
#11
i finally got around to changing my ect, iac sensors and that fixed the no start problem. now i have oil going in my intake. both valve covers are sealed and im only running the pvc and its throwing oil in my intake. i have read to close or cap pcv and get a breather on each valve cover. i have read so many options and ideas. Witch is the best and simple way. i have some valve cover breathers. if needed i could install.
#12
My car was warm after running like 50 miles one day, and I stopped and shut down the car while checking the mail...2 minutes later I tried starting it and it ran for a sec and died out like it was running out of fuel, but I smelt fuel so I knew it wasn't. 2 hours later it started right up. Asked on here, and people suggested changing the TFI module...did that and never had another problem.
Thread
Thread Starter
Forum
Replies
Last Post
92 5.0stang
5.0L (1979-1995) Mustang
4
08-13-2015 06:46 AM
Milan Dragway
Members Rides and Car Show Section
0
08-12-2015 03:43 PM