help with potential Gt40 setup!!
04-22-2011, 02:18 PM
#11
Thread Starter
Join Date: Mar 2011
Location: California
Posts: 36
I would have them him mill all the surfaces that make contact with a gasket. except the valve covers area. I would have them put in new springs. And yes! get the heads off that explorer, they are the gt40 heads. I did the same thing, got the intake, realized it was a early 97 and got to the heads and they were the gt40s. thanks man, my pitbull is a great dog! they are some of the best dogs around, nothing like them.
oh ok will do, so do you know how much i should have them milled? and what cam would be good with the whole setup ? im planning on getting 24lb hr injectors and maf sensor, my buddy is gonna fully port the heads for me, should i have them machined before i get them ported? sorry to nag im just pressed for time, i dont want to let these deals slip away
04-26-2011, 12:53 AM
#12
3rd Gear Member
Join Date: Jul 2009
Location: SoCal
Posts: 807
i don't know how much milling you want. but the machine shop will know. i like the trick flow stage one cam, thats what i plan on getting. but up to you. I would port first then take it to the machine shop, that way they clean the heads really good and remove all the metal shaves. and as for fuel, 24s are good and a new pump would be nice as well as a fuel pressure regulator.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
MustangForums Editor
General Tech
0
09-25-2015 06:42 PM
