94 Cobra 347 build
#1
94 Cobra 347 build
Hello Stangers! I'm building a 347 with a cast Scat crank and KB Hyper flat top pistons. I will be using it for 85% street, 15% track. The heads I'm using are aluminum Ford Racing X306 with about .030" milled off. I plan to lightly port them (bowl and exhaust) and use Comp Cams XE 282HR. Here comes the real question: what other upgrades should I be looking at? There is alot of info regarding GT bottlenecks, but the Cobra has lots of factory upgrades: Intake, MAF, Throttle body, 24#injectors. Are these enough to support a 347?
My other installed parts are MAC equal length shorty headers, Bassani catted X pipe, 2 chamber Flows, and 3.73 gears. Thank You.
My other installed parts are MAC equal length shorty headers, Bassani catted X pipe, 2 chamber Flows, and 3.73 gears. Thank You.
#2
I`d go with atleast 30`s, a 75mm tb and the intake is iffy!
I`d go with a bigger primary headers than 1 5/8, it will be a peppy combo with just about any decent parts!
I used the scat crank and rods with KB pistons! it has been satisfactory so far!
and a clutch upgrade will be a plus!
I`d go with a bigger primary headers than 1 5/8, it will be a peppy combo with just about any decent parts!
I used the scat crank and rods with KB pistons! it has been satisfactory so far!
and a clutch upgrade will be a plus!
#3
IMO, you need 1 3/4" longtubes for that combo.
Also, you'll need to relieve the block atb the bottom of the cylinders.
I forgot where I got it but there is a tool sold by a company off E-Bay that works great......
Also, you'll need to relieve the block atb the bottom of the cylinders.
I forgot where I got it but there is a tool sold by a company off E-Bay that works great......
Thread
Thread Starter
Forum
Replies
Last Post
MustangForums Editor
Mustang News, Concepts, Rumors & Discussion
3
11-10-2015 11:39 AM
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM