Anderson 4" Power Pipe Install
#1
Anderson 4" Power Pipe Install
Hey guys, I got a really good deal on an Anderson 4" Power Pipe. The only issue is I have a MM strut tower brace and a 3/8 inch phenolic intake spacer (Trick Flow intake). From what I have read it should clear with the MM strut tower brace, but the 3/8 inch spacer may be pushing it too far.
My questions are 1. Can you cut the hole lower for more clearance? 2. What tool should I use to make this easier? I'm thinking a 4 1/4 hole saw might not grab since there is already a 3" hole there?
Thank you in advance!
My questions are 1. Can you cut the hole lower for more clearance? 2. What tool should I use to make this easier? I'm thinking a 4 1/4 hole saw might not grab since there is already a 3" hole there?
Thank you in advance!
Thread
Thread Starter
Forum
Replies
Last Post
KillSwitchNY
5.0L (1979-1995) Mustang
10
11-07-2007 08:08 PM