Avic x920 and PAC C2R-FRD1
12-09-2010, 08:10 PM
#1
2nd Gear Member
Thread Starter
Join Date: Dec 2007
Location: CO
Posts: 292
Avic x920 and PAC C2R-FRD1
Hey I'm currently installing the X920bt and I have the PAC harness, all the wires on the x920 except for the VSS and reverse gear match up with the respective wires on the PAC harness.
Are these two wires located in the car elsewhere and if so what color are they?
Also are there any other tips for this harness or is it basically plug and play, in the directions it says something about not hooking up the green wires for the sub and just use the violet ones?
Are these two wires located in the car elsewhere and if so what color are they?
Also are there any other tips for this harness or is it basically plug and play, in the directions it says something about not hooking up the green wires for the sub and just use the violet ones?
Thread
Thread Starter
Forum
Replies
Last Post
