200 cid motor cylinder head?
#1
200 cid motor cylinder head?
So I was just wondering, and I'm pretty sure I'm right, but is the intake manifold part of the cylinder head on an L6? I've checked and don't see any seams or mounting hardware, so I'm pretty sure that's what it is. If that's the case, does anyone know where to get one? I've been looking all over and can't find one.
#2
RE: 200 cid motor cylinder head?
ORIGINAL: Craig67
So I was just wondering, and I'm pretty sure I'm right, but is the intake manifold part of the cylinder head on an L6? I've checked and don't see any seams or mounting hardware, so I'm pretty sure that's what it is. If that's the case, does anyone know where to get one? I've been looking all over and can't find one.
So I was just wondering, and I'm pretty sure I'm right, but is the intake manifold part of the cylinder head on an L6? I've checked and don't see any seams or mounting hardware, so I'm pretty sure that's what it is. If that's the case, does anyone know where to get one? I've been looking all over and can't find one.
#3
RE: 200 cid motor cylinder head?
This picture here should show you what I'm talking about. I don't see anywhere that the intake manifold can be unbolted.
[IMG]local://upfiles/32389/D9DB7DB299E04E1884CFD94AC6639C8D.jpg[/IMG]
[IMG]local://upfiles/32389/D9DB7DB299E04E1884CFD94AC6639C8D.jpg[/IMG]
#4
RE: 200 cid motor cylinder head?
Yeah, those old mustangs are like that. The intake and cylinder head are all one piece. I know it's weird but it's true
#5
RE: 200 cid motor cylinder head?
ORIGINAL: 67t5ponycoupe
Yeah, those old mustangs are like that. The intake and cylinder head are all one piece. I know it's weird but it's true
Yeah, those old mustangs are like that. The intake and cylinder head are all one piece. I know it's weird but it's true
#6
RE: 200 cid motor cylinder head?
Yup. Another trick set up on those is to get a Stock ford Holley from a I6 Granada. They work much better than the stock carb.
#7
Rebuilt 200 CID I6
I have a fresh rebuilt 200 CID according to castings a 64, Falcon/Mustang, head/intake. I could be motivated into selling this head. This would be a numbers correct head for your stang.
Good Luck, Chris
Thread
Thread Starter
Forum
Replies
Last Post
jaiidutch
Motor Swap Section
2
09-14-2015 10:29 AM