1967 GT emblem template/measurements
#1
1967 GT emblem template/measurements
Laying out the location of the G T on a 1967 FB. I have seen the template (attached) and I have acquired a few additional measurements, but looking a couple other references. If anyone can provide any of the following, it would be most helpful.
Passenger side:
- from rear of front fender (by door) to the left hand side of the G
- from rear of fender to middle of T
- from fender wheel opening to middle of T
- from upper belt line to top of T
- from rocker panel trim to bottom of T
Driver side:
- from rear of front fender (by door) to the right hand side of the G
- from rear of fender to middle of T
- from fender wheel opening to middle of T
I don't have the stripes on yet, but I am laying them out as I know that will help. Using these guides:
- lower, thin stripe starts 1/8" up from the door
- 1/2" gap all the way around the letters. Meaning the middle stripe is 1/2" back from the G and the T. Also 1/2" from the top and bottom thin stripes
Passenger side:
- from rear of front fender (by door) to the left hand side of the G
- from rear of fender to middle of T
- from fender wheel opening to middle of T
- from upper belt line to top of T
- from rocker panel trim to bottom of T
Driver side:
- from rear of front fender (by door) to the right hand side of the G
- from rear of fender to middle of T
- from fender wheel opening to middle of T
I don't have the stripes on yet, but I am laying them out as I know that will help. Using these guides:
- lower, thin stripe starts 1/8" up from the door
- 1/2" gap all the way around the letters. Meaning the middle stripe is 1/2" back from the G and the T. Also 1/2" from the top and bottom thin stripes
Thread
Thread Starter
Forum
Replies
Last Post