65turbo289

theres the lock nut on the left and i think on the right(*passenger) which one is low and which is interm. bands?

THUMPIN455

Intermediate band is the front one with adjusting nut on the drivers side.

Low reverse band is the rear most one with the adjusting nut on the passenger side.

For everyone else who might consider doing it also.

Adjustment procedure:

INTERMEDIATE BAND
1: remove and discard locknut and install a new one (more than just a good idea here folks)
2: torque adjusting screw to 10ftlbs. (thats the one inside the nut, not the nut itself)
3: Back off adjusting screw exactly
a. 1 1/2 turns on 1964 C4
b. 1 3/4 turns on 1965-1981 C4
c
4: Hold adjusting screw from turning and tighten locknut


LOW REVERSE BAND
1: loosen lock nut several turns
2: torque adjusting screw to 10ftlbs
3: Back off adjusting screw 3 full turns
4: hold adjusting screw from turning and tighten lock nut


10 ftlbs isnt very much so you will need a very small ftlb torque wrench. If you can find one that has both inch lbs and ftlbs on it, that would be the one to use.

65turbo289

PERFECT thanks!

James Morris

I assume this can be performed with trans in car. Nothing Im missing? Just crawl under....quick job.