Dash Cut
#1
Dash Cut
Working through a 65 coupe I recently purchased. The dash has been cut up a bit to accommodate a tape deck, specifically 2 additional holes where very crudely drilled for the tuning *****.
So basically replacing it with an oem look-a-like is out without replacing the dash or using one of those weld in patch kits. Any ideas for a temp fix? I would like to do it right at some point but it might be a while before I can go down that road.
Thanks
Joe
So basically replacing it with an oem look-a-like is out without replacing the dash or using one of those weld in patch kits. Any ideas for a temp fix? I would like to do it right at some point but it might be a while before I can go down that road.
Thanks
Joe
#3
Going with an OEM style stereo limits your options. They're not bad units but they're dated. Because the dash is already cut it wouldn't be a sin to cut it to DIN size, then you could install a true state of the art type unit. Unless you're a concourse kind of guy... If so, well...Never mind.
Last edited by Oxnard Montalvo; 11-29-2010 at 08:37 PM.
Thread
Thread Starter
Forum
Replies
Last Post
breaking
Audio/Visual Electronics
5
10-02-2015 01:27 PM