PReal

Its been a while since I consistantly posted on the forums but after moving to a new house it is time to start working on the stang again.

I plan on installing some fairly nice audio equipment in the car and am planning on making fiberglass A-pillar covers that will be covered in vinyl to hold tweeters.

Has anyone seen anythong similar on a classic mustang?

tx65coupe

Why not just make something smaller that would fit on the lower corner of the A pillar and the dash to hold a tweeter?

shelbymustangdan

I visited this vendor while walking around Fords at Carlisle back in June. They have some really nice interior pieces, several of which I will considering next year some time. Some of thier components include A pillars. I don't know if you can buy them seperately, but maybe you can give them a call.

http://mustangstofear.com/category_interior.php

The guy I spoke to was very nice and down to earth.

andrewmp6

You could get the abs ones from http://www.mpcustomproducts.com/ and add the tweeters to them.

PReal

I built a fiberglass housing for a set of gauges to sit where the factory center speaker wa and could build them for the tweets, but would really rather integrate into the a pillar. In addition, aiming the tweets can cause some issues with imaging that leads me to want them facing each other about 2-4 inches above the dash.



Those parts from mustangs to fear look great! Too bad the interior parts are for 67-69's.


The ABS looks cheap and hard. Whatever I make will be covered in vinyl to match the appearance of the interior.

Looks like it is time ot start laying down some glass in the near future...

andrewmp6

If your that good with fiberglass go for it,If they look good you could always make and sell them too.