Swap meet steal
#1
Swap meet steal
Found a heater box for my 66 for 4 bucks. It looks complete, but as I dont have one, I have nothing to compare it with. It doesnt have a resistor and doesnt look to have holes for it either.
How do I install this and does it need a resistor? How do I know if I have a two speed or three speed setup?
Thanks!
How do I install this and does it need a resistor? How do I know if I have a two speed or three speed setup?
Thanks!
#2
The 1966 Mustangs utilized a resistor panel in the front of the heater box. Your Mustang will have a three speed heater switch on the dash - off to the left, low, medium, and high as the switch moves to the right. The box you have is for a 1965 Mustang or early Falcon. You can simply cut a rectangular opening in the front of the box for the resistor panel installation.
Best,
Al
Best,
Al
Thread
Thread Starter
Forum
Replies
Last Post
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
10-05-2015 07:16 AM
folivier
Tennessee Regional Chapter
4
10-02-2015 05:32 AM
nmra1965
Other Professional Racing
0
09-26-2015 10:46 AM