Help me figure out what master cylinder this is
#1
Help me figure out what master cylinder this is
Hey everyone, haven't been on here in a while.
My master cylinder started leaking, and I was barely able to limp my car home keeping shifts to a minimum.
I did the T5 swap probably 12 years ago or so, and I can't for the life of me figure out what kit I used.
Does anyone recognize this master cylinder?
Do I need to go back with the same, or is there another that will work?
Can these be rebuilt?
I can't get it out just yet till I get someone over to hold against me on the other side of the firewall.
Thanks in advance!
My master cylinder started leaking, and I was barely able to limp my car home keeping shifts to a minimum.
I did the T5 swap probably 12 years ago or so, and I can't for the life of me figure out what kit I used.
Does anyone recognize this master cylinder?
Do I need to go back with the same, or is there another that will work?
Can these be rebuilt?
I can't get it out just yet till I get someone over to hold against me on the other side of the firewall.
Thanks in advance!
#2
a 3/4" CNC. (Chuck Norris Company) or some **** like that
yes it can be rebuilt
Call CNC up and get the kit
Might not be a bad idea to verify the ID of the bore...using the guts they can help you figure out which rebuild kit is proper.
yes it can be rebuilt
Call CNC up and get the kit
Might not be a bad idea to verify the ID of the bore...using the guts they can help you figure out which rebuild kit is proper.
Last edited by Gun Jam; 08-19-2017 at 11:05 PM.