Clutch suggestions
#1
Clutch suggestions
I put this same thread on the fox page but I thought i would list it here too since its getting to the time of year when I start driving my car again.
I have a 66 but it has a new T5 with a 92 block based 347. I have converted it to a hydraulic clutch. I am currently running a dual friction clutch with a slave outside the trans.
It is now time to get a new clutch, So
What is the best clutch for a very hard driven street car. I will take it to a strip once in while.
would I get better performance with a hydraulic throwout bearing instead of using my current slave cylinder.I i have had several issues with it coming out of adjustment
with the current adjustment stud. So i frequently need to jack it up and readjust it. even after using a jam nut and thread lock.
I have a 66 but it has a new T5 with a 92 block based 347. I have converted it to a hydraulic clutch. I am currently running a dual friction clutch with a slave outside the trans.
It is now time to get a new clutch, So
What is the best clutch for a very hard driven street car. I will take it to a strip once in while.
would I get better performance with a hydraulic throwout bearing instead of using my current slave cylinder.I i have had several issues with it coming out of adjustment
with the current adjustment stud. So i frequently need to jack it up and readjust it. even after using a jam nut and thread lock.
Thread
Thread Starter
Forum
Replies
Last Post