pastang

This question has probably been asked and answered a million times but I can't find it. I am trying to install a set of BBK subframe connectors with seat brackets. When I tried to put them on the rear of the unibody there is some sort of bracing in the way. Do I need to take that off. I tried calling bbk but there tech did not know what bracing I was talking about. Any i pics or advice about removing the bracket would be appreciated.

1989 5.0 vert

CW5billwade

New edge Vert comes with sub fram conectors not sure about 89

pastang

89's don't I'm just trying to see if I need to take the bracing off

lizzyfan

Try the 5.0 section

Riceinator

Are they weld in or bolt in connectors? What area do you need pics of? At the front subframe, at the torque box reinforcements or the seat brackets?

pastang

They are bolt on and weld on. I would like pics of the rear subframe
thanks

Riceinator

ok, i got some pics, but they are all blurry. I will go out again tomorrow and try with a better camera, or maybe better photographer.

pastang

any pics yet?

ga chopper

weld as much as u can try to level the car before u start