Convertible Tech This section is only for questions or information relating to a convertible. Questions about drivetrain modifications should still be posted in the engine specific sections.
Sponsored by:
Sponsored by:

Drivers side top latch 03 cobra

Thread Tools
 
Search this Thread
 
Old 05-21-2017, 09:42 AM
  #1  
mustangman02232
6th Gear Member
Thread Starter
 
mustangman02232's Avatar
 
Join Date: Dec 2004
Location: Ludlow, Mass
Posts: 15,864
Default Drivers side top latch 03 cobra

So at some point during my drive yesterday the pin on the windshield header fell out, does anyone know where I can get replacements? It's the little dowel pin that the J hook hooks to on the windshield side not the big guide pin on the top side
mustangman02232 is offline  
Old 05-21-2017, 03:54 PM
  #2  
Z28KLR
4th Gear Member
 
Z28KLR's Avatar
 
Join Date: Nov 2009
Location: SoCal
Posts: 1,826
Default

I've not noticed them for sale anywhere, if it were me though I would dig around on CL for a local car being parted out. I just went out to the garage and looked at my car.... Looks like a bit of a pain in the ***, as you will probably have to replace that entire piece of the latch. If you still have the pin that fell out maybe pull the rest of the A pillar latch and see if you can get it back in there.
Z28KLR is offline  
Old 05-22-2017, 04:52 AM
  #3  
dawson1112
5th Gear Member
 
dawson1112's Avatar
 
Join Date: Jul 2012
Location: ohio
Posts: 3,628
Default

You have to replace the entire section

Cheap used.
http://www.ebay.com/itm/99-04-Ford-M...tYsdok&vxp=mtr
dawson1112 is offline  
Old 05-22-2017, 10:20 AM
  #4  
mustangman02232
6th Gear Member
Thread Starter
 
mustangman02232's Avatar
 
Join Date: Dec 2004
Location: Ludlow, Mass
Posts: 15,864
Default

Thanks,seems kind of like a pain in the ***, I lost the pin which is why I'm looking for one, I pulled the pillar down far enough to get a 5mm bolt to thread into where the pin goes for the time being but it's not as tight or the way iit should be

It's come out a few times before and it always fell on the floor, no such luck this time
mustangman02232 is offline  
Old 05-22-2017, 11:45 AM
  #5  
dawson1112
5th Gear Member
 
dawson1112's Avatar
 
Join Date: Jul 2012
Location: ohio
Posts: 3,628
Default

Originally Posted by mustangman02232
Thanks,seems kind of like a pain in the ***, I lost the pin which is why I'm looking for one, I pulled the pillar down far enough to get a 5mm bolt to thread into where the pin goes for the time being but it's not as tight or the way iit should be

It's come out a few times before and it always fell on the floor, no such luck this time
If you do happen to find it and can screw it back in,, use som loc-tite on the threads.
dawson1112 is offline  




All times are GMT -5. The time now is 06:48 AM.