Haze28

Got my loudmouths on tuesday and finally put them on last night. It took about 45 minutes to get them on but I had a little problem getting the passenger side to tuck up close like the drivers side is. I played with it for a while but it still isn't where I want it. Does anyone have any suggestions? It's only off by about a quarter of an inch and barely noticable but I see it and I don't like it.
As far as the sound goes, I think it's amazing. I can see how anyone thinks it's too loud, it's got a nice deep tone at idle and sounds mean at WOT. Brings a smile to my face every time I step on it. These cars were meant to be heard!!!!

Stang Skeleton

The Loud Mouths tend to have this problem of eveness on each side. You really have to play around with them to get it about equal and even then it probably wont be exact. The only way to really get them even is to have them welded. That is the only guaranteed fix, but if you dont want to have it welded then you have to get it down to a science to get them even or at least looking like they are.

RCT06GT

Yeah, just tweak with it a little. My passenger side was off too.

Haze28

The only thing I haven't tried is actually bending the hanger alittle. Should I even try to do that?

01RobGT

Yeah you may have to bend the hanger a little to get where you need it. My MAC axle back did the same thing and is still a little off. Gotta get some time and work at it to get it right.

ren274u

this happened yesterday when i put my frpp stingers on, i just loosened the clamps after the x pipe, or h, and had someone hold the mufflers where i wanted them and tightened.