Broken 3650 5 speed
#1
Broken 3650 5 speed
Anyone else had problems with the roll pins shearing off of the shifter rail for 1st&2nd? This is twice I have had to replace the roll pins that hold the shifter fork to the shift rail because they were sheared off.
#4
RE: Broken 3650 5 speed
I havent heard of that problem yet. I know of two local guys that blew out their tranny while messing up the shift to third at the track, but I do not specifically know what happened to the trans.
#5
RE: Broken 3650 5 speed
I messed up my tranny trying to shift into 3rd when I first got my car. (3 months ago) It went into 1st at 70. I realized it right away and put the clutch back in before the rpm could get near the rev limiter. My car has not been the same since. It rumbles and virbates when its cold. The drive train just noisier in general. It's not as fast either. When its gets hot it really bogs at low rpms and just has no guts what so ever. It runs perfect only in moderate temperature conditions. I've been to the dealer 4 times and they wouldnt do anything because it would never act up for them. Thankfully they finally agreed to take it for a few days to put it through the ringer. Anyway its been an absolute nightmare. Good luck with your problem.
Thread
Thread Starter
Forum
Replies
Last Post
BeatnikFink
New Member Area
6
10-01-2015 08:00 PM
MustangForums Editor
General Tech
0
09-25-2015 06:58 PM