Went to the dyno
#1
Went to the dyno
Here's my dyno run after installing the Steeda CMCP
http://img107.imageshack.us/img107/3...raph001zl7.jpg
http://img107.imageshack.us/img107/3...raph001zl7.jpg
#2
RE: Went to the dyno
Hmmmm,
Nice numbers there, your A/F looks good too. A few questions though.
1) What were your numbers prior to the mod?
2) What gear did they do the run in?
3) What were the conditions?
4) Why don't your HP and Torque numbers cross at ~5200 rpm?
Thanks!
Nice numbers there, your A/F looks good too. A few questions though.
1) What were your numbers prior to the mod?
2) What gear did they do the run in?
3) What were the conditions?
4) Why don't your HP and Torque numbers cross at ~5200 rpm?
Thanks!
#3
RE: Went to the dyno
1) 297 rwhp, 303 torque not too sure about that since I don't have the old graph.
2) It was made in 4 gear
3) It was very humid since it was raining a little bit and about 80 to 85 degrees.
4) I don't kno the answer to that question but I was asking the same thing.
2) It was made in 4 gear
3) It was very humid since it was raining a little bit and about 80 to 85 degrees.
4) I don't kno the answer to that question but I was asking the same thing.