SES light after C&L install
#1
SES light after C&L install
I put a C&L CAI on my GT last night and it threw a SES light. The MAF is in the right way, and everything else is hooked up right. The car runs fine. What can I do to get rid of this light?
#2
RE: SES light after C&L install
did you also flash the engine with a new tune? the light is due to too much airflow.....the C+L CAI needs a new tune.....otherwise your stock PCM will throw codes because of your airflow past the MAF....
#4
RE: SES light after C&L install
ORIGINAL: cheftjpeck
did you also flash the engine with a new tune? the light is due to too much airflow.....the C+L CAI needs a new tune.....otherwise your stock PCM will throw codes because of your airflow past the MAF....
did you also flash the engine with a new tune? the light is due to too much airflow.....the C+L CAI needs a new tune.....otherwise your stock PCM will throw codes because of your airflow past the MAF....
Richard
#5
RE: SES light after C&L install
+1 to the posts above. I took my tune off to take to the dealer but left the C&L on and the light came on on the way back from the dealer. Loaded the tune again and all was fine.
Thread
Thread Starter
Forum
Replies
Last Post
Soldier GT
4.6L (1996-2004 Modular) Mustang
12
08-20-2015 09:42 AM