Charge motion dlete and Supercharging
#1
Charge motion dlete and Supercharging
Just a quick reply needed form anyone who knows if deleting the charge motions would be good to do while as I'm going with a vortech supercharger and intercooler next week and may do delete plates while im at it
#2
RE: Charge motion dlete and Supercharging
Yes. It is a very good idea to do with a centri SC. There have been reports of CMCP plates being bent by the boost of centrifugal SCs and turbos--this creates a major flow restriction.
This is not a concern on screw blowers which delete the CMCPs as a matter of course.
This is not a concern on screw blowers which delete the CMCPs as a matter of course.
#3
RE: Charge motion dlete and Supercharging
ORIGINAL: CrazyAl
Yes. It is a very good idea to do with a centri SC. There have been reports of CMCP plates being bent by the boost of centrifugal SCs and turbos--this creates a major flow restriction.
This is not a concern on screw blowers which delete the CMCPs as a matter of course.
Yes. It is a very good idea to do with a centri SC. There have been reports of CMCP plates being bent by the boost of centrifugal SCs and turbos--this creates a major flow restriction.
This is not a concern on screw blowers which delete the CMCPs as a matter of course.
#7
RE: Charge motion dlete and Supercharging
As others already pointed out - the safety concerns far outway any HP gains. Yep, might see 'some' but who cares. Get them to save your motor. Just ask Justin Burcham what happens when you leave them in...
He grenanded his block when the butterflys bent and his procharger was pushing 18 psi through one cylinder.
He grenanded his block when the butterflys bent and his procharger was pushing 18 psi through one cylinder.
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM