engine block?????????
I was just woundering what everyones opion on wether to forge my block or buy one already forged. i have an 06 mustang gt with paxton 2200. any place or web sites to go please let me know.
|
RE: engine block?????????
surprisingly, i may be asking this very same question, some day....
not sure what you should do, there are too many unknown variables. ORIGINAL: kenholley2122 I was just woundering what everyones opion on wether to forge my block or buy one already forged. i have an 06 mustang gt with paxton 2200. any place or web sites to go please let me know. |
RE: engine block?????????
Personally, I'd go the already assembled route. Just easier that way.
|
RE: engine block?????????
you dont need to change the block but if you do i would buy another block. that way you can do an engine swap and not worry about taking apart the stock engine
|
RE: engine block?????????
ORIGINAL: kenholley2122 I was just woundering what everyones opion on wether to forge my block or buy one already forged. i have an 06 mustang gt with paxton 2200. any place or web sites to go please let me know. BTW remember to lower your compression ratio (8:1-8.5:1). And ooh...almost forgot...check out these links: www.dssracing.com www.seanhylandmotorsport.com www.livernoismotorsports.com |
RE: engine block?????????
SHM in da hizzi!
|
RE: engine block?????????
I say go pre-assembled...just sell the other one! lol, make some money back.
|
RE: engine block?????????
what SHM block did you get.
|
All times are GMT -5. The time now is 11:28 PM. |
© 2024 MH Sub I, LLC dba Internet Brands