Yonco

well, i hope not, sounds great, the first 30 seconds of running it will pop when the rpm's decrese cause its cold, but besides that, and im sure its restricted enough to avoid valve problems, as its a full exhaust, a set of longtubes with cutouts would serve a chunk of less , and i even have highflow cats. Anways, I belive the SLP Loudmouths are just a set of pipes that replace the mufflers( so ive heard) and ive only heard of burnt valves from running a car with to big of primarys on a set fo headers or someone messing around running it w/ no headers. but a full exhaust w/ cats should be enough. -Jon

22kart22

Wait, I'm confused. Did you just get it? Or is that just a new hood?!!

Yonco

The hood came on the car, and the car is NEW to me, well about 2 months old now. The kit is a B2, i think, thats the closest i could find.
http://cgi.ebay.com/ebaymotors/Part-...spagenameZWDVW

the PO worked at a performance shop and had it modded more, but took it off before giving it to a dealer buddy who i got it from. it had an intake, but that was pulled off and i am still unsure if i have a tune, but ive been using 87-89 octane.

And the idea of getting "boss" was because ive had people acutally ask me if its a new boss mustang??? and this picture:

http://www.rawhorsepower.com/2008-Bo...rsepower_L.jpg

-Jon

Boozshey

Well at first I thought you had a FOOSE hood, but you said it's fiberglass so I know it's not that, it for sure is not a Cervini B2. The Cervini B2 extends the hood another 3 inches or so and has a couple other pieces that fit onto the headlight areas to make it sit flush again...

But slapping it with BOSS is still a bad idea, the BOSS if and when it's released will have a 5.0 in it. So to me it's like slapping on cobras when it's not, or having a v6 and slapping GT on it, people do it, it's it right, not in my opinion. But like they always say, it's your car...

But other than that your car is looking good, throw some new shoes on, lower it and FI, you will be on your way. Remember though with the Shaker, the easiest way to a SC is to get a centrifugal. The screw type will work, but will be a lot more fabbing to get it to fit right.

05 Mustang

cough, cough, Vortech with Intercooler....





[IMG]local://upfiles/50057/FF30CDCECE8A4D94A6232FB9C9336C7F.jpg[/IMG]

[IMG]local://upfiles/50057/EC7CECC4B5844CBD96B6A2029D66B134.jpg[/IMG]