aeroforce Fuel Pressure sensor..anyone have this installed?
#11
RE: aeroforce Fuel Pressure sensor..anyone have this installed?
ORIGINAL: hotairgypsy
I am getting ready to install the Saleen SC but I am getting everything else installed before the blower..
1. boost gauge and aeroforce
2. weld in bung for O2
3. O2 sensor to aeroforce for air/fuel mix
4. GT500 fuel system upgrade possibly at BAP
5. Catch can for tranny blowoff
6. possibly the breather oil catch can for the pcv from what i have been reading
all the above steps doesnt take the car down in case i need it plus it has been in for 40s weather wise ...baby steps
7. take car fully down for Saleen SC install
I have the setup on it for about 13lb boost all my readings are telling me to drop to 8-10lbs so the stock block has a fighting chance of living.
I am getting ready to install the Saleen SC but I am getting everything else installed before the blower..
1. boost gauge and aeroforce
2. weld in bung for O2
3. O2 sensor to aeroforce for air/fuel mix
4. GT500 fuel system upgrade possibly at BAP
5. Catch can for tranny blowoff
6. possibly the breather oil catch can for the pcv from what i have been reading
all the above steps doesnt take the car down in case i need it plus it has been in for 40s weather wise ...baby steps
7. take car fully down for Saleen SC install
I have the setup on it for about 13lb boost all my readings are telling me to drop to 8-10lbs so the stock block has a fighting chance of living.
Andrew
#12
RE: aeroforce Fuel Pressure sensor..anyone have this installed?
ORIGINAL: hotairgypsy
one gauge shows two readings...a dual is two gauges showing two readings each for a total of 4 readings
one gauge shows two readings...a dual is two gauges showing two readings each for a total of 4 readings
Andrew
#14
RE: aeroforce Fuel Pressure sensor..anyone have this installed?
i have chrome bezel, black face, and white writing and i have no issues reading ...i was out today in the car and could read it just fine.
Thread
Thread Starter
Forum
Replies
Last Post