2011 Gt with Boss 302 Intake - Dyno
#1
2011 Gt with Boss 302 Intake - Dyno
Took the ride to Excessive Motorsports to get a dyno with the new Boss 302 Intake.
Mods: Borla Atak CB, Steeda CAI, Bama 93 Race Tune, Boss 302 Intake
GT has 1000 miles on it and the Dyno was set to cut the throttle at 7000 rpm'w
Don't have a baseline though..
Final pull...
http://digitalman.smugmug.com/Other/...302011a-XL.jpg
Mods: Borla Atak CB, Steeda CAI, Bama 93 Race Tune, Boss 302 Intake
GT has 1000 miles on it and the Dyno was set to cut the throttle at 7000 rpm'w
Don't have a baseline though..
Final pull...
http://digitalman.smugmug.com/Other/...302011a-XL.jpg
#3
Actually, that is not bad at all for rear wheel output.
As for there being no base line, that is okay, because your output numbers do show a marked improvement over stock which is usually about 360-375 HP at the wheels.
As for there being no base line, that is okay, because your output numbers do show a marked improvement over stock which is usually about 360-375 HP at the wheels.
#4
OP, btw, your car looks great. Love the red n back setup.
#5
Thanks.
#6
Really haven't had a chance to drive it much since the install... but feels good so far!
#10
Just curious, are you going to get a tune that allows the rev limiter not to kick in until 7500 RPM?
If you can run your engine to that (which is the redline of the actual Boss 302 redline), I bet you will see a bit more wheel HP since your torque curve is staying on like white on rice!
If you can run your engine to that (which is the redline of the actual Boss 302 redline), I bet you will see a bit more wheel HP since your torque curve is staying on like white on rice!