Exhaust Rattle at Low RPM
Ok, so I am going nuts at low RPM's. I have Stainless Works Cat backs on my 2013 GT. They all went on fine no issues, but then I noticed when I would hit a bump the passenger side would bang into the rear valance. Fixed that with a little tack weld, now it vibrates at low rpm and I assume its hitting the axle. Stainless Works cuts really close to it where it comes over the axle. So any idea's on making it stop beyond tack welding more lol?
|
Typically, clearances can be changed by loosening the various joint clamps and adjusting each section of pipe but it usually takes 2 people to get it right. But if you've welded joints, you're on your own...
|
Check the hanger bracket also, my exhaust rattles at certain low rpms against the hanger bracket.
|
As Nuke said and it goes a lot better if you adjust and tighten from back to front.
|
All times are GMT -5. The time now is 07:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands