06 GT -vs- Mach 1?
#7
RE: 06 GT -vs- Mach 1?
i've never seen a stock mach run these times. i've got a buddy who has a significantly modded 04, now granted it is an auto but he could barely pull on me when i was stock...and only after a tune (forget the rest of the mods) forget about it...he couldnt hang
i'd love to see some slips on a stock (or even one with just an exhaust) running low 13's or high 12's...not saying that it's not fact, i just have never seen it
i'd love to see some slips on a stock (or even one with just an exhaust) running low 13's or high 12's...not saying that it's not fact, i just have never seen it
#8
RE: 06 GT -vs- Mach 1?
I raced a yellow Mach 1 @ Lebanon Valley NY last fall. He ran 13.3 with a stick and a Predator tuner. I was only running 13.8 with an auto and a Predator tuner. Both cars were on stock rubber. I ran against a blue Mach @ Raceway park NJ in October. He ran the identical 13.3 with a stick. I'm not sure of the motor status but he was running street drag radials.
#9
RE: 06 GT -vs- Mach 1?
Sorry if I misunderstood but was that with the 4.10's. I would imagine a slightly faster time with the mods listed below. Or are you saying you had ONLY a predator tuner? Thanks for clearing it up.
ORIGINAL: tradetheoex
I raced a yellow Mach 1 @ Lebanon Valley NY last fall. He ran 13.3 with a stick and a Predator tuner. I was only running 13.8 with an auto and a Predator tuner. Both cars were on stock rubber. I ran against a blue Mach @ Raceway park NJ in October. He ran the identical 13.3 with a stick. I'm not sure of the motor status but he was running street drag radials.
I raced a yellow Mach 1 @ Lebanon Valley NY last fall. He ran 13.3 with a stick and a Predator tuner. I was only running 13.8 with an auto and a Predator tuner. Both cars were on stock rubber. I ran against a blue Mach @ Raceway park NJ in October. He ran the identical 13.3 with a stick. I'm not sure of the motor status but he was running street drag radials.
Thread
Thread Starter
Forum
Replies
Last Post
breaking
Audio/Visual Electronics
5
10-02-2015 01:27 PM