Bottom end mods for s/c + nitrous
#1
Bottom end mods for s/c + nitrous
What type of bottom end mods am I looking at if I install both a s/c and nitrous? I will not be driving like a bat out of hell on a regular basis, but I don't want anything exploding when I punch the gas either.
#2
RE: Bottom end mods for s/c + nitrous
I can't tell you the "minimum" amount of upgrading needed for forced induction with nitrous (hell, chevykiller ran both at over 500rwhp on the stock bottom end for a good little while and it held)......so I will just suggest that you do a full shortblock forging: rods, pistons, crank. At the very LEAST I would do that.
Thread
Thread Starter
Forum
Replies
Last Post
Dragonus18
4.6L (1996-2004 Modular) Mustang
8
09-09-2015 01:21 AM