jchittick

Here is my stock manifolds, MAC offroad H and Flowmaster series 40's.

Exhaust Clip

Shaken

Bassnai o/r x Delta 40 2 chamber Flows I installed 2.5" Pypes Stainless Flow Tubes and had the 2.25" Stainless mufflers swelled up on the inlet side to 2.5" so I could use my factory tail pipes. Had to keep it in the budget. I think it came out pretty good.
http://www.youtube.com/watch?v=2LtY2PvPnt4

jchittick

I clicked on your link and got " The URL contained a malformed video ID."

Try it again, I want to hear it...

Shaken

http://www.youtube.com/watch?v=2LtY2PvPnt4

groundpounder

Rebel, if you still want my H, this is what your Mach will sound like, except in person it's a lot deeper - the acoustics of the video really don't do the sound any justice.
Loudern hell in person and throaty...

jchittick

Agreed, this was taken from a camera, not a true video camera. Sounds 10X better in person.

groundpounder

yeah, your vid sounded like *** [&:]

J/K - I know what it sounds like in person cuz mine was same!

B.O.B MACH 1

Are o2 sensor extensions required when installing the mac o/r H pipe or will the sensors reach the bungs stock length?

Subotai_95

I don't really know about the MAC H's, but I had to get an O2 sensor extension harness for the mach when I installed my SLP H pipe.. Then I also had long-tubes too though.. If you're running mids you might not need to.. I'd get the extensions just in case and then if you don't need them you can always return them..

jchittick

I rigged mine up. I spliced the wires and made my own extensions so I didn't have to buy anything. Then I just had them turned off in my tune.