Cobra Eaton on a mach
#1
Cobra Eaton on a mach
what do you guys know about swapping a cobra eaton on a mach 1? theres one for sale in my area for $950, comes with basically everything cept a cobra ecu.
S/C
TB
Maf
injectors
http://i21.photobucket.com/albums/b2...t/PB050013.jpg
S/C
TB
Maf
injectors
http://i21.photobucket.com/albums/b2...t/PB050013.jpg
#2
I know to do the swap will cost as much as buying a centrifugal kit. There is a ton of little pieces you have to buy. I hate to link to a different site but this thread has pretty much everything you need to know about the swap.
http://www.mach1registry.org/forums/...ad.php?t=71833
http://www.mach1registry.org/forums/...ad.php?t=71833
#3
yeah definitely check that list, because that has ALL the parts you will need, and there a lot more than you think haha
A full kit typically will go for ~$3500, which isn't too bad...but then you have to upgrade your fuel system (i.e. to cobra pumps+tank) to get some good power
A full kit typically will go for ~$3500, which isn't too bad...but then you have to upgrade your fuel system (i.e. to cobra pumps+tank) to get some good power
#5
It's been discussed in incredible detail at M1R:
http://www.mach1registry.org/forums/...ad.php?t=71833
You need a LOT of parts other than those. I think it's a little more than 60 total. Basically a Terminator top end. Buying all the parts new is an insane amount, but if you're extremely patient you can piece a kit together for relatively cheap.
http://www.mach1registry.org/forums/...ad.php?t=71833
You need a LOT of parts other than those. I think it's a little more than 60 total. Basically a Terminator top end. Buying all the parts new is an insane amount, but if you're extremely patient you can piece a kit together for relatively cheap.
Thread
Thread Starter
Forum
Replies
Last Post
breaking
Audio/Visual Electronics
5
10-02-2015 01:27 PM