Midnight Blue WS6 on Racestars
10-18-2011, 09:40 AM
#11
1st Gear Member
Thread Starter
Join Date: Oct 2011
Location: columbus, oh
Posts: 139
I actually didn't put the centric rings on, the rims fit fine without them because I put 5/16" spacers in. I needed spacers because I have the stock panhard bar so the passenger side rear tire was rubbing on the inside so I needed a little gap, everything fits very well though.
10-18-2011, 01:26 PM
#14
2nd Gear Member
Join Date: Jul 2011
Location: ky
Posts: 469
10-18-2011, 03:08 PM
#15
1st Gear Member
Thread Starter
Join Date: Oct 2011
Location: columbus, oh
Posts: 139
Holy Tire! You sure you need that much tire? anything above a 275 IMO is overkill and will actually hurt your car more than help it, also you will most likely need aftermarket rear axles and a big spacer for that tire to fit in your fender. How much power are you making? and a word of advice you don't need MT front runners....you can get a set of nexxen fronts for $140 shipped or local pickup to save you some money.
10-19-2011, 12:29 AM
#16
2nd Gear Member
Join Date: Jul 2011
Location: ky
Posts: 469
Holy Tire! You sure you need that much tire? anything above a 275 IMO is overkill and will actually hurt your car more than help it, also you will most likely need aftermarket rear axles and a big spacer for that tire to fit in your fender. How much power are you making? and a word of advice you don't need MT front runners....you can get a set of nexxen fronts for $140 shipped or local pickup to save you some money.
10-19-2011, 07:53 AM
#17
1st Gear Member
Thread Starter
Join Date: Oct 2011
Location: columbus, oh
Posts: 139
Not much power at all, lol. if i had to guess i would say around 260 to 270 rwhp. But i have big plans for the car.I love the FAT and skinny look. And they will fit with out spacers. Thats the widest and tallest tire that will fit, with out modifying anything.I wanted a tall tire to kill some of the gear im running ( 4.10s). Im going to do a few mods to it this winter since its not my daily driver.
10-19-2011, 10:35 AM
#19
1st Gear Member
Thread Starter
Join Date: Oct 2011
Location: columbus, oh
Posts: 139
10-19-2011, 10:57 AM
#20
2nd Gear Member
Join Date: Jul 2011
Location: ky
Posts: 469
Im going to build a complete motor for it and it will be either turbo or supercharged. I think this winter i will buy a n20 kit and spray the motor that is in it. If it blows i really wont care. lol. With a 100 shot the car should run 7.50s to 7.70s. That would take care of the bogging of the line, lol. What all is done to your ride? The car i would guess weighs around 3000 lbs, i took some weight out of it. So hopefully that will help get it out of the hole a little better.