Let me introduce my car
#1
Let me introduce my car
I posted this info in another thread... just found this board (as you can tell from my 10 posts in 2 days) and I have to say I enjoy it! Anyway, wanted to introduce my car... I was trying for a somewhat old-school look for a modern mustang... puts 400 horse power and about the same torque to the rear wheels, which seems a bit lame so far, but... anyway, it is far from done, and has its problems, but overall, hope it is up to standards!
[IMG]local://upfiles/26391/D48648565323454A9B496FDD50B3A490.jpg[/IMG]
Rebuilt 4.6 (8.75-1 compression) with forged manley rods, pistons, cobra crank, PI heads
rebuilt t-45 tranny
Vortech S-Trim Supercharger w/12 psi pulley
SCT chip
3.73 Gears
Centerforce Clutch Kit
Steed TriAx Shifter
75mm FMS Throttle Body
255 Intank Pump
Mass Air Meter
42lb injectors
alumn. drive shaft
Baer Track Claw brake system
Steeda Suspension Kit
Kenny Brown Subframe Connectors
17 x 9.5 Front, 17 x 11 Rear American Racing Wheels, w/ Sumitomo 315s out back.
Bassani X-Pipe
Flowmaster Mufflers
Shelby Stripes and Side Stripes
35th Anniv. Hood Scoop
Rosewood interior
Mach 1 Shifter bezel and **** (not installed when pictures were taken)
Mach 1 Front Chin Spoiler
White Faced Guages
Bullitt Gas Tank Cap
Hood Pins (just for fun)
Bass Tube (in trunk)
[IMG]local://upfiles/26391/81D48C0F66B147079205D8A934412D79.jpg[/IMG]
[IMG]local://upfiles/26391/D48648565323454A9B496FDD50B3A490.jpg[/IMG]
Rebuilt 4.6 (8.75-1 compression) with forged manley rods, pistons, cobra crank, PI heads
rebuilt t-45 tranny
Vortech S-Trim Supercharger w/12 psi pulley
SCT chip
3.73 Gears
Centerforce Clutch Kit
Steed TriAx Shifter
75mm FMS Throttle Body
255 Intank Pump
Mass Air Meter
42lb injectors
alumn. drive shaft
Baer Track Claw brake system
Steeda Suspension Kit
Kenny Brown Subframe Connectors
17 x 9.5 Front, 17 x 11 Rear American Racing Wheels, w/ Sumitomo 315s out back.
Bassani X-Pipe
Flowmaster Mufflers
Shelby Stripes and Side Stripes
35th Anniv. Hood Scoop
Rosewood interior
Mach 1 Shifter bezel and **** (not installed when pictures were taken)
Mach 1 Front Chin Spoiler
White Faced Guages
Bullitt Gas Tank Cap
Hood Pins (just for fun)
Bass Tube (in trunk)
[IMG]local://upfiles/26391/81D48C0F66B147079205D8A934412D79.jpg[/IMG]
#5
RE: Let me introduce my car
They arent EXACTLY what I was looking for at the time I got them, but they had the width I needed Wanted a touch more of the torque thrust rims, but couldnt find them in 11 inch wide
#9
RE: Let me introduce my car
you need to open up the head get it ported so its more free flowing, also you dont have cam and your cam can only push so much its probably restricting you, your head is probly the restricter is why it may feel underpowered, open that head up and i gauruntee you and extra 65 or 70 horsepower
Thread
Thread Starter
Forum
Replies
Last Post
92 5.0stang
5.0L (1979-1995) Mustang
4
08-13-2015 06:46 AM
Milan Dragway
Members Rides and Car Show Section
0
08-12-2015 03:43 PM