boost questions
#1
boost questions
i have a 95 mustang with a vortech v2 supercharger system. i just installed a cheap dragon gauge, and it gets -9 during idle. I drove it yesterday, and i had to almost redline to get the boost to register 3-4 psi. this is suppose to be set up 6-7psi. the sheave on the supercharger looks to be about 3.5" diameter.
Does this seem right?
Does this seem right?
#3
ok thanks, wasnt aware of the boost area.
Interesting didnt even think of the tension. it seemed tight, but maybe not tight enough? i thought the tensioner keeps it tight?
thanks for the help!
#4
Where in OK are you located? Shot in the dark, your kit would be at 6-7 psi at sea level. But some places in OK are around 3500 ft in elevation.
I ran into the same problem here in CO, a smaller pulley on my TVS fixed that problem.
I ran into the same problem here in CO, a smaller pulley on my TVS fixed that problem.
#6
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
AMAlexLazarus
AmericanMuscle.com
3
10-02-2015 08:06 AM
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM
treesloth
New Member Area
4
09-28-2015 07:03 AM