N/A to 04 terminator charger
Hey guys.. new to the Ford world so I was looking for some insight. I purchased a 99 cobra and have access to a stock 04 terminator charger. I was wondering if I can put this on my cobra and what other parts I would need to do this. Will the stock 04 intake bolt to my motor?
|
I am familiar with forced induction and I'm keeping it a dd so I know the basics. I was just wondering what stock stuff would be interchangeable. Or what aftermarket parts would be good to use.
|
Do a search for Eaton swap. There is a huge laundry list of parts needed to install the Eaton.
|
Pretty extensive list of parts are needed. And I believe you will have to grind your knock sensor bosses down. Best bet IMO is to buy a complete eaton swap setup or you may end up getting nickel and dimed trying to buy each little piece separately. Essentially the timing cover, bulley bridge/pulley setup. Blower, lower intake and some misc wiring pigtails etc.
|
All times are GMT -5. The time now is 07:38 PM. |
© 2024 MH Sub I, LLC dba Internet Brands