Kyle@ROUSH

Check it out guys, just a little something we did to show the potentional with our TVS superchargers while ironing out some stuff for our Phase 2/3 setups to come.




"Our development team has been busy at work finalizing our PHASE 2 and PHASE 3 kits for the 2015 Mustang. Attached is a recent dyno run for a development vehicle showing rear wheel horsepower with a stock engine and PHASE 1 kit hardware with the following upgrades: 75mm supercharger pulley, upgraded fuel injectors, revised version of our 2011-2014 fuel pump booster kit, and minor calibration enhancements. Testing was done using 93 octane with stock manifolds and stock catalytic converters. As you can see, our PHASE 1 hardware is MORE THAN capable of making in excess of 800 horsepower at the crank. Stay tuned for more on our PHASE 2 and PHASE 3 kits coming soon!"

Evilwilly

Hey Kyle I was wondering if ya'll were planning on making the phase 2/3 available for automatics and if so could you give me ball park answer on when they would be released.

thanks in advance

UPRSharad

Wow. NICE!

Kyle@ROUSH

^Thanks !




As for Phase 2/3 in the past we offered 1 and 2 for automatics however not phase 3. I am really hoping we make an auto cal for all 3 kits given the overwhelming demand for the phase 1 auto cal. As for release dates I would expect phase 2 end of summer or early this fall.

Evilwilly

Sweet

Whats the hp and torque of the phase 2 roughly going to be?

Kyle@ROUSH

The official numbers arent out we're looking 700+ HP

Evilwilly

I can't wait to see what the final numbers will be now lol.
and I might have to get one