kpaulhus

Stock height in the front was just over 28 inches from the ground to the center lip of the fender. Check it out...maybe that will help you determine.

TEXASGT/CS

kpaulhus, thanks you dont happen to have the dim for the rear do you? I will take some measurements tonite and post up the results.

wingman75

If they're blue i think they're Roush like mine. You can see by the after and before pics how much it dropped. This is a 1.25" drop from stock.

TEXASGT/CS

Well when I got home I crawled underneath and both the front and back springs are blue not the stock black. I measured from the lip to the floor in the front I got 27.75" and the rear were 28.5". Taco Bill had a write that showed the front at about 28.625" and the rear about 29.875". so I am thinking this is about a 1.25" drop.
When I looked at the springs I did not see anything that would tell me what kind they are, The Rousch that I have seen on line have had there name on them, the Steeda"s that I have seen have not had any writing on there. I looked up the FRPP springs and they were the wrong color of blue. So by means of deduction I am going to say that I have the Stedda Ultra Lite Springs with about a 1" drop in the front and 1.25" drop in the rear.

Poco

I would agree ,they look like my Steedas in color.The drop looks about the same also.

Your car looks great by the way.

TEXASGT/CS

thanks, Poco. And to everybody else that helped me out.

Hicompression

They must have been the small outfit off of Arkansas Lane in Grand Prairie. It wasn't a very big shop. You're the first one I've heard about owning one of their customs. Lawler was much bigger.

StickShifty

wow, thank good i decided to return my steeda springs. i am looking for something a bit lower.

gtguyonli

Looks almost stock too me?

3.73-11

here's a comparison for ya, stock

lowered on bmr springs

slammed on H&R coilovers

how low is to low? ")