J95SNAKE

For those who run them; is their any noise associated with their plates? I want to get as much camber as I can during autocross events but I don't want any rattles, etc. while daily driving it. I am not a fan of the camber bolts. We used those last year and I did not like them.

Jay@Hypermotive

I like ground control CC plates. +-3° of camber adjust ability. Billet aluminum tops and they come with their own bearings and spring isolators. We use them on our 13 boss, they're quiet as well.

Entaille

I have MM c/c plates and I did not notice any new noise with them. Been riding on them for nearly a year now

silverstang23

I have them with my v3's and have noise if they are stiff. It's not really a rattle or a squeak. It almost sounds like air compressing. You have to have the ac and radio off to be able to hear it. I would get them again. You can stop the noise with grease

J95SNAKE

I had MM's plates on my '95 Cobra and didn't make a single sound. They worked very well. I went ahead and ordered them today. Need to get ready for autocross which starts up in 2 weeks.

Matt's 95 Stang

I had them on my 95 too and didnt hear anything from them.

Matthew

Sam Strano

I sell and use a lot of MM plates. Never had anything bad to say about them, and don't get noise complaints.

J95SNAKE

I appreciate the responses. I was supposed to be autocrossing a '12 Boss 302 in STX this year but my co-driver traded it on a '13 Boss and doesn't want to autocross it until later this year. So...we are adding components to mine for our Mar 3 event.

snake40

I put them on my 2008 GT 500 and they were dead quiet.
I just ordered a set from Sam Strano today. He's the guy who just commented in this thread. Give him a try.
Mike

Scott2

MM Plates on my 08 and no complaints about noise.