07 GT Convertible Suspension Upgrade
#1
07 GT Convertible Suspension Upgrade
I just installed new BMR lower control arms front and rear as well as BMR A Arm support and pan hard bar. I also installed Eibach Pro Kit lowering springs. I haven't had it aligned yet, but when I turn hard left to the stop, my left rim scrapes the BMR Control arm. Is this just an alignment issue? Any thoughts?
#2
Steering Rack problem
Well after an alignment and still having the problem of my stock rims still scraping the BMR A arm, I did some research and figured it out. The steering rack has a bushing on the inside of the protective boot of both tie rods. Unfortunately when I inspected the passanger side, no bushing, hence the wheels were allowed to travel further than factory spec. Glad it's an easy fix, just have to get the parts.
Thread
Thread Starter
Forum
Replies
Last Post
LivingInThePast
Classic Mustangs (Tech)
2
09-16-2015 12:20 PM
mungodrums
Suspension
0
09-07-2015 07:22 PM