Spring swapping / lowering
#1
Spring swapping / lowering
Will 2011 up front coil springs fit an 08 Mustang? I have a set of Eibach front lowering springs left over from a kit, and a 08 that needs lowering.
The springs are actually listed for an '11-'13. [part number 4.12535f]
The springs are actually listed for an '11-'13. [part number 4.12535f]
#3
So normally speaking the front ends from 05 and up are similar enough that the coils should be the same?
#4
Sportlines FTW! I took a look at some pictures and compared the tech specs between the Eibach springs for the different years, and there are very subtle differences between the two. If it were my car, I wouldn't put coils on that are not designed for the specific year of the vehicle. I'm sure there is a reason why Eibach is separating the 05+ and 11+. Then again, there could just be a difference in bump stops/shock boots. I would call them and figure out why they're year specific. I know patience is tough to attain when it comes to our mustangs. Hang in there!
Last edited by yourmom6990; 08-02-2015 at 09:49 PM.
#6
#7
Updating spring question
Bringing up my old tread as I now have another question on another set of Eibach springs. I just gave the part numbers to Eibach who identified these as a set of 4 springs for the 05-10 Mustang GT. When I asked if they would physically fit the 11-14 he said no. When I asked why he simply said "they changed the suspension"! I know there would be different ratings for 11 up due to the 5.0 engine, but physically would they fit?
Thread
Thread Starter
Forum
Replies
Last Post