Avoid Wilwood brakes
#11
Do these calipers not have dust boots for the pistons? I'm not sure how much of that is dirt and how much are irregularities in the finish, but it bothers me to see so much of the pistons exposed. Makes me think that they might be hanging up.
#12
The pistons are so exposed because the pads are worn to nothing and the caliper is slightly off center. The real question is what caused the pads to wear in a taper and the stock answer is rotor exiting the caliper upside down. Other than that, there is no reason for the pads to wear in that fashion. There is clearly too much pressure being applied by the large pistons which are supposed to be down exit. Based on my view of the rotor vents, the rotors are on the wrong side of the car because the seem to be exiting at the top instead of the bottom. I would love to see a pic of the rotors to see which way the slots are if slotted.
Last edited by proeagles; 08-15-2017 at 03:38 PM.
#13
3rd Gear Member
Thread Starter
Join Date: Oct 2007
Location: Santo Domingo, Dominican Republic
Posts: 920
I'll see if I can get any more pictures. There's definitely uneven pressure being applied to the pads, but this caliper and rotor kit is less than 3 months old. New fluid, Wilwood pads. 2 track days to get to that state.
#14
If you go to the Wilwood site and look up installation tips, it is pretty clear that there is an installation issue. The calipers are mounted incorrectly somehow. Assuming the bleed screws are in the up position, the larger piston must be on the bottom if the caliper is installed on the front side of the axle and on the top if the caliper is installed on the rear of the axle. The small piston is for the rotor entrance into the caliper and the larger piston is for the exit. Assuming all of that is correct in this case then clearly there is a manufacturing defect and Wilwood would love to know about it.
#15
3rd Gear Member
Thread Starter
Join Date: Oct 2007
Location: Santo Domingo, Dominican Republic
Posts: 920
If you go to the Wilwood site and look up installation tips, it is pretty clear that there is an installation issue. The calipers are mounted incorrectly somehow. Assuming the bleed screws are in the up position, the larger piston must be on the bottom if the caliper is installed on the front side of the axle and on the top if the caliper is installed on the rear of the axle. The small piston is for the rotor entrance into the caliper and the larger piston is for the exit. Assuming all of that is correct in this case then clearly there is a manufacturing defect and Wilwood would love to know about it.