MustangForums.com - Search Results


Showing results 1 to 25 of 125
Search took 0.24 seconds.
Search: Posts Made By: 7 UP Mustang
Forum: 5.0L (1979-1995) Mustang 11-30-2017, 04:55 PM
Replies: 10
Views: 270
Posted By 7 UP Mustang
Check fuel pump pressure and make sure you have...

Check fuel pump pressure and make sure you have some good gas in the tank. Is this a DD?
Forum: General Tech 11-20-2017, 07:02 PM
Replies: 10
Views: 437
Posted By 7 UP Mustang
Make sure the speedometer cable is inserted...

Make sure the speedometer cable is inserted properly into the back of the speedometer. Good luck!
Forum: V6 (1994-2004) Mustangs 04-29-2017, 09:33 AM
Replies: 7
Views: 353
Posted By 7 UP Mustang
I would recommend that you check your firing...

I would recommend that you check your firing order. Did you replace the plug wires one at a time? Is it possible you might have got that wrong. I always go back to the last thing I did before the...
Forum: 2005-2014 Mustangs 04-17-2017, 10:12 AM
Replies: 11
Views: 870
Posted By 7 UP Mustang
When the engine warms up is the radiator building...

When the engine warms up is the radiator building up pressure? The radiator hose should feel firm at about 15 pounds of pressure that depends on the radiator cap rating. If no pressure on the hose...
Forum: Convertible Tech 03-07-2017, 05:27 PM
Replies: 6
Views: 813
Posted By 7 UP Mustang
Sounds like the brushes inside the motor are not...

Sounds like the brushes inside the motor are not making proper contact with the armature. I had to buy brushes for my 1990 LX convertible, and sanded them down to fit. That was about 12 years ago,...
Forum: GT S197 General Discussion 05-09-2014, 09:06 AM
Replies: 11
Views: 3,610
Posted By 7 UP Mustang
Steve did you check the cabin filter?

Steve did you check the cabin filter?
Forum: 4.6L V8 Technical Discussions 03-28-2014, 10:20 AM
Replies: 24
Views: 2,751
Posted By 7 UP Mustang
Sounds like a lifter problem, but it might be an...

Sounds like a lifter problem, but it might be an exhaust leak around the front part of the car. Also 5W-20 sounds like it might be too thin. What does the manual recommend for the oil. Good luck!
Forum: 4.6L V8 Technical Discussions 03-21-2014, 09:47 AM
Replies: 5
Views: 823
Posted By 7 UP Mustang
Sounds like you might need a front end alignment...

Sounds like you might need a front end alignment and balance job. In the mean time check for bent rims up front. Jack up the front end and spin the wheels to see if there is any deviation from true....
Forum: 5.0L (1979-1995) Mustang 06-12-2013, 04:29 PM
Replies: 17
Views: 1,354
Posted By 7 UP Mustang
I used a oil can that has the built in pump, and...

I used a oil can that has the built in pump, and just squeezed in about two pumps in each plug hole. Sounds like you lost the sealing effect of the rings due to getting too hot, and burning the oil...
Forum: 5.0L (1979-1995) Mustang 06-12-2013, 10:53 AM
Replies: 17
Views: 1,354
Posted By 7 UP Mustang
You might try this old trick! Take the plugs back...

You might try this old trick! Take the plugs back out, and squirt some motor oil into each plug hole. Crank it over about twice to spread the oil around, and redo your compression check!

Good...
Forum: 2005-2014 Mustangs 06-02-2013, 10:05 AM
Replies: 2
Views: 486
Posted By 7 UP Mustang
I am assuming the top is in good condition, and...

I am assuming the top is in good condition, and the rear window is still properly sealed. Check the drain tubes for the top. You have one on each side under the rear area near the tires. If you park...
Forum: 4.6L (1996-2004 Modular) Mustang 05-29-2013, 07:39 PM
Replies: 12
Views: 812
Posted By 7 UP Mustang
Yes pull the driver's side door panel, and check...

Yes pull the driver's side door panel, and check the master up and down switch. Make sure you are getting power to the switch and then that it is going out of the switch. . Very unlikely both motors...
Forum: V6 S197 General Discussion 05-23-2013, 02:02 PM
Replies: 11
Views: 1,263
Posted By 7 UP Mustang
Did you replace the radiator pressure cap? You...

Did you replace the radiator pressure cap? You said you replaced the reservoir cap, I guess you mean the over flow reservoir cap. Could be a bad pressure cap or the radiator is restricted due to...
Forum: 5.0L (1979-1995) Mustang 05-15-2013, 05:16 PM
Replies: 2
Views: 754
Posted By 7 UP Mustang
Check the wiper switch and or wiring up to the...

Check the wiper switch and or wiring up to the wiper relay. Sounds like the relay is being energized all the time. If so the new relay will do the same thing.

Good Luck!
Larry
Forum: 5.0L (1979-1995) Mustang 05-13-2013, 04:03 PM
Replies: 6
Views: 627
Posted By 7 UP Mustang
MY old 7 UP Convertible had a broken rear window...

MY old 7 UP Convertible had a broken rear window for a couple of years before I replace the complete top and window. The only time we drove it was during nice weather with the top down. While it was...
Forum: 5.0L (1979-1995) Mustang 05-10-2013, 04:27 PM
Replies: 15
Views: 742
Posted By 7 UP Mustang
MY top motor was completely dead with the bad...

MY top motor was completely dead with the bad brushes. They had worm down so far that they did not make the connection to the commutator pat of the armature. Motor still works to this day!

Good...
Forum: V6 (1994-2004) Mustangs 05-10-2013, 10:21 AM
Replies: 4
Views: 2,083
Posted By 7 UP Mustang
Did you do a good visual inspection to make sure...

Did you do a good visual inspection to make sure there is no corrosion on the sockets? Maybe remove all the bulbs for the brake lights as it could be a bad socket. Definitely drawing too much current...
Forum: 5.0L (1979-1995) Mustang 05-09-2013, 03:23 PM
Replies: 15
Views: 742
Posted By 7 UP Mustang
The UP and DOWN relays are back in the top...

The UP and DOWN relays are back in the top compartment. You can get to them by going into the trunk, and removing that cover that protects the top motor parts. If I recall the spare tire cover and...
Forum: 5.0L (1979-1995) Mustang 05-08-2013, 09:12 PM
Replies: 15
Views: 742
Posted By 7 UP Mustang
On my 7 UP Mustang I had a bad relay one time,...

On my 7 UP Mustang I had a bad relay one time, and the brushes were worn out another time. I swapped the relays around to verify that one was bad. You might try that since the relays just plug in and...
Forum: 4.6L (1996-2004 Modular) Mustang 05-04-2013, 09:40 AM
Replies: 14
Views: 2,030
Posted By 7 UP Mustang
You do not have to remove the drain pan. There is...

You do not have to remove the drain pan. There is an over sized thread cutting bolt you can screw back into the oil pan. There is a link below that explains it in detail. Good luck!

Fixing A...
Forum: Classic Mustangs (Tech) 05-02-2013, 09:35 AM
Replies: 7
Views: 747
Posted By 7 UP Mustang
IT has been a long time since I replaced points,...

IT has been a long time since I replaced points, but sounds like they were not set properly.
Forum: 5.0L (1979-1995) Mustang 04-30-2013, 05:03 PM
Replies: 4
Views: 402
Posted By 7 UP Mustang
I had some bad brushes inside my motor. They had...

I had some bad brushes inside my motor. They had worn down so bad that the power was not getting to the armature. Ford does not sell new brushes but I did make a set that I had to custom fit, and...
Forum: 5.0L (1979-1995) Mustang 04-29-2013, 11:23 AM
Replies: 16
Views: 10,039
Posted By 7 UP Mustang
MY 1990 LX has two relays, and one went out. The...

MY 1990 LX has two relays, and one went out. The easy thing to do is to swap the relays around since they are plug in types. One is used for UP and one is used for DOWN. In my case a new relay fixed...
Forum: V6 S197 General Discussion 03-24-2013, 04:40 PM
Replies: 261
Views: 19,369
Posted By 7 UP Mustang
I just might be the oldest ONE here! So much fun...

I just might be the oldest ONE here! So much fun not owning a Grandpa car. We have had 3 Mustang Convertibles and we love our new, 2013, FGB Premium V6. It has all the goodies I wanted to put on the...
Forum: 4.6L General Discussion 07-07-2012, 11:17 AM
Replies: 9
Views: 1,050
Posted By 7 UP Mustang
This is not an easy problem, but you have to...

This is not an easy problem, but you have to start some place troubleshooting. When it is running "hot" is the fan still running or perhaps it is cutting off too soon. Another thing to check is the...
Showing results 1 to 25 of 125

 
Forum Jump
Advertising
Featured Sponsors
Vendor Directory

All times are GMT -5. The time now is 11:49 PM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.