MustangForums.com - Search Results


Showing results 1 to 25 of 498
Search took 0.12 seconds.
Search: Posts Made By: yurizx6r
Forum: 5.0L (1979-1995) Mustang 08-28-2017, 01:41 PM
Replies: 2
Views: 180
Posted By yurizx6r
Just got off the phone with performance...

Just got off the phone with performance distributors. They said that if you have an MSD box then leave your TFI module in distributor stock. The aftermarket TFI module gives you better Spark by...
Forum: 5.0L (1979-1995) Mustang 08-28-2017, 11:48 AM
Replies: 13
Views: 800
Posted By yurizx6r
How new was the motor and when did you tune it?...

How new was the motor and when did you tune it? Also, check your spark (test coil, plugs, wires, check for vacuum leaks, and yeah you could also be getting used to it, but if it's popping then...
Forum: 5.0L (1979-1995) Mustang 08-28-2017, 11:40 AM
Replies: 5
Views: 376
Posted By yurizx6r
I would bet money that it's your ignition coil,...

I would bet money that it's your ignition coil, what's going on is that you don't have enough spark to get it turned over, and then even when you can get it turned over it's running rich because not...
Forum: 5.0L (1979-1995) Mustang 08-28-2017, 11:38 AM
Replies: 5
Views: 376
Posted By yurizx6r
#1 suspect: Ignition coil. I'm pretty sure it's...

#1 suspect: Ignition coil. I'm pretty sure it's that. #2 Suspect: TFI module. You can pull both off and test them or go to a local auto zone and have them checked. And if you need a new one DON'T GET...
Forum: 5.0L (1979-1995) Mustang 08-27-2017, 04:21 PM
Replies: 4
Views: 289
Posted By yurizx6r
How could you expect your car to run properly...

How could you expect your car to run properly without any O2 sensors?
Forum: 5.0L (1979-1995) Mustang 08-27-2017, 08:48 AM
Replies: 2
Views: 180
Posted By yurizx6r
Just in case anybody is wondering, my experiences...

Just in case anybody is wondering, my experiences with MSD have been the following: burned through three coils within two years, brand new TFI module didn't work out of the box, brand new distributor...
Forum: 5.0L (1979-1995) Mustang 08-27-2017, 08:45 AM
Replies: 2
Views: 180
Posted By yurizx6r
Ignitor Question (TFI module)

Hey guys,

My basic question is, can the TFI module inhibit the flow of electricity to the point that it could damage your ignition coil? Being perfectly honest here, I don't fully understand what...
Forum: 5.0L (1979-1995) Mustang 05-27-2017, 08:23 AM
Replies: 8
Views: 521
Posted By yurizx6r
It seems like your parking brake cable could be...

It seems like your parking brake cable could be too tight. That would be my first suspect. It could also be that one of your pistons are somewhat seized or at least not functioning properly. I'd...
Forum: 5.0L (1979-1995) Mustang 05-04-2017, 09:25 AM
Replies: 3
Views: 269
Posted By yurizx6r
My gut tells me no, but who knows. Like I said,...

My gut tells me no, but who knows. Like I said, the only time I noticed any difference was when I put the 6AL box on and my MSD coil went bad.
Forum: 5.0L (1979-1995) Mustang 05-04-2017, 07:13 AM
Replies: 3
Views: 269
Posted By yurizx6r
Spark plug wires question

Hey guys, I'm board, and I was curious about something. Do you think you would actually notice a difference in anyway between Ford Racing 9mm spark plug wires and the MSD Super Conductor or the Live...
Forum: 5.0L (1979-1995) Mustang 03-31-2017, 07:06 AM
Replies: 19
Views: 1,069
Posted By yurizx6r
After REALLY looking at my setup, I’ve come to...

After REALLY looking at my setup, I’ve come to the conclusion that it would look like complete crap if I cut the fenders unless I had Chip Foose do it. My hand isn’t that steady, I don’t trust...
Forum: 5.0L (1979-1995) Mustang 03-27-2017, 05:03 PM
Replies: 19
Views: 1,069
Posted By yurizx6r
Both wheels are spinning. I just verified it a...

Both wheels are spinning. I just verified it a few days ago.
Forum: 5.0L (1979-1995) Mustang 03-21-2017, 08:04 PM
Replies: 15
Views: 698
Posted By yurizx6r
Ok. Just making sure it wasn't an ignition issue....

Ok. Just making sure it wasn't an ignition issue. It's not popping under WOT right? It's tuned correctly and all that? Either way good job getting a Motorcraft IAC. Can't beat OEM on some things.
Forum: 5.0L (1979-1995) Mustang 03-21-2017, 07:01 PM
Replies: 15
Views: 698
Posted By yurizx6r
Hey sorry, but I didn't see your original thread....

Hey sorry, but I didn't see your original thread. What's the overall problem? Also, did you do a base idle reset with the car warm?
Forum: 5.0L (1979-1995) Mustang 03-20-2017, 08:04 PM
Replies: 15
Views: 698
Posted By yurizx6r
Spend the money on a Motorcraft IAC. Those cars...

Spend the money on a Motorcraft IAC. Those cars are notorious for bad IACs. I've tried a few BWD ones (all junk) that lasted a few months, tried a Duralast one which seemed ok, but finally spent the...
Forum: 5.0L (1979-1995) Mustang 03-16-2017, 10:10 AM
Replies: 19
Views: 1,069
Posted By yurizx6r
@Boss Hotrod: That's cool. I'm probably going to...

@Boss Hotrod: That's cool. I'm probably going to eventually put it on either way just because.... race car. lol But, I wanted to figure out this underline issue first. My camshaft calls for a MINIMUM...
Forum: 5.0L (1979-1995) Mustang 03-16-2017, 08:32 AM
Replies: 19
Views: 1,069
Posted By yurizx6r
Got yah. These responses were not what I...

Got yah. These responses were not what I expected, but certainly appreciate them. I guess I'll have to really find a place to practice more to figure out the limitations of the new power I have while...
Forum: 5.0L (1979-1995) Mustang 03-15-2017, 01:44 PM
Replies: 19
Views: 1,069
Posted By yurizx6r
It is true that I need a little more experience...

It is true that I need a little more experience learning how to correct it when the rear end loses control, but there's no place to really practice that where I live. It's a pretty heavily populated...
Forum: 5.0L (1979-1995) Mustang 03-15-2017, 06:08 AM
Replies: 6
Views: 721
Posted By yurizx6r
The car was designed to run copper top plugs, so...

The car was designed to run copper top plugs, so I just use MGK copper tops with Ford Racing wires. However, you will not notice any difference until you put in a MSD ignition box like a 6AL. That's...
Forum: 5.0L (1979-1995) Mustang 03-14-2017, 06:34 PM
Replies: 19
Views: 1,069
Posted By yurizx6r
My #1 goal is to keep it straight if the tires...

My #1 goal is to keep it straight if the tires spin. I don't care if the spin, just don't fishtail or over steer on me. I've seen too many stangs on medians to not take that seriously. Without a dyno...
Forum: 5.0L (1979-1995) Mustang 03-13-2017, 05:33 PM
Replies: 19
Views: 1,069
Posted By yurizx6r
Maximum Motorsports Panhard Bar

Hey guys,

I was wondering if anybody has installed a MM panhard bar. What I would really like to know is two things? 1. Do you get a lot of noise inside the car/ does it make it less DD friendly?...
Forum: 5.0L (1979-1995) Mustang 03-13-2017, 05:26 PM
Replies: 9
Views: 632
Posted By yurizx6r
That certainly helps! lol But I would still take...

That certainly helps! lol But I would still take it to a local tuner who can tune YOUR car. Bama will get you moving, but it's not a good tune doing it from another state just taking wild shots and...
Forum: 5.0L (1979-1995) Mustang 03-13-2017, 05:21 PM
Replies: 3
Views: 244
Posted By yurizx6r
I had a similar issue to where my fox wouldn't...

I had a similar issue to where my fox wouldn't start easily. It seemed fine once you got it started, but anything after 3,000 RPMS it would backfire. After checking the fuel pressure, battery, vacuum...
Forum: 5.0L (1979-1995) Mustang 11-11-2016, 12:19 PM
Replies: 8
Views: 314
Posted By yurizx6r
That's the 2nd time MSD has let me down. I bought...

That's the 2nd time MSD has let me down. I bought a MSD distributor and the second I put it in the idle went crazy and kept dying on me (installed it correctly, I've done tones of those). I put the...
Forum: 5.0L (1979-1995) Mustang 11-10-2016, 09:03 PM
Replies: 11
Views: 775
Posted By yurizx6r
Ok. I tried advancing my timing on my chain by 3...

Ok. I tried advancing my timing on my chain by 3 degrees once (YES I DID IT RIGHT, you cant screw it up), turned it by hand to make sure it was good, and then it wouldn't start. I had to play with...
Showing results 1 to 25 of 498

 
Forum Jump
Advertising
Featured Sponsors
Vendor Directory

All times are GMT -5. The time now is 10:44 PM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.