- Search Results

Showing results 1 to 25 of 140
Search took 0.21 seconds.
Search: Posts Made By: eaturls1
Forum: 5.0L (1979-1995) Mustang 02-29-2008, 09:18 AM
Replies: 20
Views: 7,624
Posted By eaturls1
RE: 331 stroker and twisted wedge?

yes they will work just fine on 331
Forum: 5.0L (1979-1995) Mustang 02-29-2008, 09:16 AM
Replies: 14
Views: 870
Posted By eaturls1
RE: nitto nt555r

nittos suck on mustangs
Forum: 5.0L (1979-1995) Mustang 02-29-2008, 09:14 AM
Replies: 13
Views: 809
Posted By eaturls1
RE: drag tires

i would go with the mickey thompson 275/60/15 drag radials. make sure to get them nice & hot & they will stick
Forum: 5.0L (1979-1995) Mustang 02-29-2008, 09:09 AM
Replies: 5
Views: 375
Posted By eaturls1

yes the should work as long as you dont change heads to dofferent style ports.
Forum: 5.0L (1979-1995) Mustang 02-29-2008, 09:07 AM
Replies: 15
Views: 812
Posted By eaturls1
RE: Muffler choice?

i had ravin mufflers on my 5.0 & sounded great & not that many people have them. you can get them at midas.they are discontinued but they now sell vortex muffler but it is the same thing
Forum: 5.0L (1979-1995) Mustang 02-29-2008, 09:03 AM
Replies: 7
Views: 666
Posted By eaturls1
RE: 90 gt oil leak

it might be the intake seal between the heads that is a common problem.
Forum: 5.0L (1979-1995) Mustang 11-29-2007, 04:07 PM
Replies: 14
Views: 724
Posted By eaturls1
RE: IRS from 03 cobra into a fox???

what the f*ck are you thinking?
Forum: 5.0L (1979-1995) Mustang 11-29-2007, 04:06 PM
Replies: 2
Views: 313
Posted By eaturls1
RE: Helppppp pleasee

clean or replace idle air control motor.
Forum: 5.0L (1979-1995) Mustang 11-29-2007, 04:05 PM
Replies: 7
Views: 902
Posted By eaturls1
RE: Equal Length Header Install?

why are you putting on equal length headers. headers should come with bolts & gaskets. changing plugs will be a lil bit harder but you can do it. if you have common sense you should be able to put...
Forum: 5.0L (1979-1995) Mustang 11-29-2007, 04:03 PM
Replies: 10
Views: 1,818
Posted By eaturls1
RE: Battery wont hold a charge

start car and pull off neg. batt cable while running if it shuts off it is not charging. if it stays running then the alt. is charging.
Forum: 5.0L (1979-1995) Mustang 11-26-2007, 03:58 PM
Replies: 4
Views: 420
Posted By eaturls1
RE: exhaust question

it sounds like you have some bad valve seals on the side that is smoking.
Forum: 5.0L (1979-1995) Mustang 11-26-2007, 03:56 PM
Replies: 14
Views: 675
Posted By eaturls1
RE: breaks

it could the caliper slides, caliper or the hose could be even holding pressure.check slides first if the slides are moving fine open bleeder screw and if brake fluid shoots out like its under...
Forum: 5.0L (1979-1995) Mustang 11-26-2007, 03:49 PM
Replies: 19
Views: 806
Posted By eaturls1
RE: breaklines

check your local ford dealer.
Forum: 5.0L (1979-1995) Mustang 11-14-2007, 03:57 PM
Replies: 3
Views: 314
Posted By eaturls1
RE: Head Gasket ?

just use stock head gaskets. i had 306 putting out 400 horse with stock head gaskets .they did just fine.
Forum: 5.0L (1979-1995) Mustang 11-14-2007, 03:53 PM
Replies: 8
Views: 534
Posted By eaturls1
RE: beeping noise

just unplugg sensors in door jambs.
Forum: 5.0L (1979-1995) Mustang 11-14-2007, 03:50 PM
Replies: 11
Views: 810
Posted By eaturls1
RE: Timing Chain and Gear

doesnt look your pushing 700 horsepower a stock replacement chain will do you just fine.
Forum: 5.0L (1979-1995) Mustang 11-14-2007, 03:47 PM
Replies: 3
Views: 282
Posted By eaturls1
RE: lincoln drivetrain will it work?

make sure the rear end is the same width. i think some of them are a little wider than mustang rear end.
Forum: 5.0L (1979-1995) Mustang 11-14-2007, 03:45 PM
Replies: 3
Views: 774
Posted By eaturls1
RE: Ford Racing Water Temp Guage installation

yea there should be a single pin sender in water jacket of intake manifold.
Forum: 5.0L (1979-1995) Mustang 11-14-2007, 03:42 PM
Replies: 14
Views: 2,201
Posted By eaturls1
RE: My car won't stop leaking coolant!! Help please!!

as far as the leak on water pump the timing chain cover is probably bad. mine did the same thing. put 3 different water pumps on still leaked. replaced the ting cover and went away. good luck
Forum: 5.0L (1979-1995) Mustang 06-07-2006, 03:50 PM
Replies: 1
Views: 307
Posted By eaturls1
RE: Steering Colum to Rack question

it is called a 12 point socket genius
Forum: 5.0L (1979-1995) Mustang 06-07-2006, 03:47 PM
Replies: 4
Views: 265
Posted By eaturls1
RE: Suspention Pics

i would prolly stay away from that car
Forum: 5.0L (1979-1995) Mustang 06-07-2006, 03:46 PM
Replies: 10
Views: 769
Posted By eaturls1
RE: Grinding noise in rearend...

it could also be the limited slip clutches going bad
Forum: 5.0L (1979-1995) Mustang 06-07-2006, 03:43 PM
Replies: 6
Views: 433
Posted By eaturls1
RE: dry gas?

i do the same thing and it seems to be workin fine for me so far.
Forum: 351 Mustang 05-23-2006, 02:31 PM
Replies: 5
Views: 1,610
Posted By eaturls1
RE: 351w swap

everything should bolt right up. the motor is a lil wider than 5.0.
Forum: 5.0L (1979-1995) Mustang 05-23-2006, 02:30 PM
Replies: 11
Views: 546
Posted By eaturls1
RE: did i get a good deal?

sounds like a good deal to me
Showing results 1 to 25 of 140

Forum Jump
Featured Sponsors
Vendor Directory

All times are GMT -5. The time now is 08:49 AM.

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.