MustangForums.com - Search Results

Go Back  MustangForums.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Tribesman
Showing results 1 to 23 of 23
Search took 0.34 seconds.
04-01-2009, 01:41 AM
Replies: 121
Views: 75,195
Posted By Tribesman

How 'bout these: ...

How 'bout these:
...
03-31-2009, 11:15 PM
Replies: 26
Views: 5,609
Posted By Tribesman

What about a 5.4 swap how-to?

What about a 5.4 swap how-to?
06-07-2008, 12:44 AM
Replies: 48
Views: 2,320
Posted By Tribesman

RE: new trick flow intake manifold

I wonder how this one compares to the Buillitt intake?
11-20-2007, 11:45 PM
Replies: 10
Views: 14,047
Posted By Tribesman

RE: how do i install fuel injectors?

You may also want to completely remove the battery or at least disconnect the neg term (for safety purposes only). Just my 2cents.
11-19-2007, 11:05 PM
Replies: 12
Views: 716
Posted By Tribesman

RE: Engine Missing out

Damn, after all of this I STILL have the engine miss. I’ve replaced the fuel filter and all ignition coils. Checked all 8 plugs (everything normal there), ran 2 bottles of water remover and 1 can...
11-15-2007, 10:46 AM
Replies: 12
Views: 716
Posted By Tribesman

RE: Engine Missing out

Just found a set of Jacobs coils at Summit Racing for $190. They also had the Accel brand for $224.
11-14-2007, 07:09 PM
Replies: 12
Views: 716
Posted By Tribesman

RE: Engine Missing out

[sm=jawdrop.gif]

Think I'll stick to the used set from the Mark VIII (provided they fit). I just hope I don't inherit another bad one from the used set.
11-14-2007, 06:38 PM
Replies: 12
Views: 716
Posted By Tribesman

RE: Engine Missing out

How much does a new set of 8 coils usually cost?
11-14-2007, 06:34 PM
Replies: 12
Views: 716
Posted By Tribesman

RE: Engine Missing out

Yeah, I have a coworker that hasa leftover set of coils from a Mark VIII. I'm not sure if they're the same though. I'll find out tomorrow and see if that's the problem. The real challenge will be...
11-13-2007, 10:20 PM
Replies: 12
Views: 716
Posted By Tribesman

Engine Missing out

Help! I have an 02 GT w/ 105k miles. Recently the engine has been missing out. At first I thought it might be water in the gas. But after 2 bottles of Heet, no difference. I also replaced the fuel...
11-07-2007, 11:43 PM
Replies: 8
Views: 447
Posted By Tribesman

RE: jet hot

I believe you can go to them direct but I could be wrong. Try this link:
http://www.jet-hot.com/pages/getestimate.php
11-03-2007, 12:23 AM
Replies: 4
Views: 432
Posted By Tribesman

11-02-2007, 08:31 PM
Replies: 4
Views: 432
Posted By Tribesman

Estimating HP increases

About how much HP and torque would this yield at the flywheel on an 02 GT?


CAI
75mm TB & upper plenum
UD pulleys
LT headers
Hi-flow cats
Cat back exhaust
Diablo chip custom...
10-31-2007, 11:32 PM
Replies: 11
Views: 638
Posted By Tribesman

RE: 04 headers?

Do the jet-hot coated headers protect against rust?
10-27-2007, 06:32 PM
Replies: 3
Views: 608
Posted By Tribesman

RE: Suspension upgrade advice needed

Thanks. I think I will purchase those bolts.

I had also heard that it's a good idea to dial in a little bit of negative camber to offset the lowering. If that's true how much negative camber...
10-27-2007, 02:26 AM
Replies: 3
Views: 608
Posted By Tribesman

Suspension upgrade advice needed

Just recently received some suspension upgrades for my 2002 Mustang GT (daily driver): subframe connectors, lowering springs ( 1 to 1.5 inches ), shocks & struts and rear lower control arms. I plan...
Forum: South West
10-13-2007, 11:40 PM
Replies: 0
Views: 443
Posted By Tribesman

Welder in OKC area

Hey all. I'm looking for a reputable shop in the Shawnee/OKC area to weld a set of subframe connectors on my 2002 GT. Any recommendations?
Forum: South West
10-13-2007, 11:31 PM
Replies: 99
Views: 18,716
Posted By Tribesman

RE: How man okies?

I'm in the thriving metropolis of Shawnee.
10-13-2006, 03:27 AM
Replies: 11
Views: 1,213
Posted By Tribesman

10-13-2006, 03:24 AM
10-08-2006, 06:46 PM
Replies: 11
Views: 1,213
Posted By Tribesman

RE: T3650 Must Go!!!

Sent you a reply.
10-08-2006, 05:39 AM
Replies: 11
Views: 1,213
Posted By Tribesman

RE: T3650 Must Go!!!

Would you part with it for $450?
Showing results 1 to 23 of 23


 
Forum Jump

Advertising
Featured Sponsors
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.