MustangForums.com - Search Results

Notices
 
Search: Posts Made By: mattdel
Showing results 1 to 25 of 499
Search took 0.17 seconds.
02-14-2014, 05:05 PM
Replies: 5
Views: 641
Posted By mattdel

Cruising speed misfires/bucks are usually a...

Cruising speed misfires/bucks are usually a result of a vacuum leak induced by the EGR system. O2 reading lean would seem to concur.
12-15-2013, 04:54 PM
Replies: 11
Views: 580
Posted By mattdel

Do the radiator and fan absolutely last. Give you...

Do the radiator and fan absolutely last. Give you more room to work, especially the balancer bolt.
12-15-2013, 11:29 AM
Replies: 18
Views: 1,512
Posted By mattdel

180 is the preferred modders thermo temp for EFI...

180 is the preferred modders thermo temp for EFI cars. 195 is stock and is optimal for emissions standards.

The zip ties should be just fine. Crank down all 4 corners and it won't go anywhere.
...
12-14-2013, 09:55 PM
Replies: 18
Views: 1,512
Posted By mattdel

You have 2 coolant sensors in the manifold, the 2...

You have 2 coolant sensors in the manifold, the 2 wire is for the computer. On the other side of the intake is a single wire sensor, that's for the gauge. You could tap it or drill/tap a new hole...
12-14-2013, 06:10 PM
Replies: 3
Views: 717
Posted By mattdel

Some people purchase an IAC adjuster plate that...

Some people purchase an IAC adjuster plate that allows fine tuning of idle with forced induction applications, but your problem is the MAF. You need one calibrated for 30# injectors.
12-02-2013, 10:49 PM
Replies: 3
Views: 430
Posted By mattdel

I can't say for certain that the fox mustang had...

I can't say for certain that the fox mustang had this, I simply don't remember, but a pressure sensor in the steering lines is responsible for bumping the idle a tiny bit while not moving so that you...
12-01-2013, 04:13 PM
Replies: 5
Views: 789
Posted By mattdel

Set the gun to 0 and put the balancer on 10.

Set the gun to 0 and put the balancer on 10.
12-01-2013, 03:21 PM
Replies: 18
Views: 1,512
Posted By mattdel

Don't tap anything for items with high amperage...

Don't tap anything for items with high amperage draws. Create a new circuit off the switched side of the starter solenoid(the one with tons of wires as opposed to the single one). Although I don't...
11-21-2013, 11:36 PM
Replies: 9
Views: 679
Posted By mattdel

Stock alternators put out a whopping 60 amps. If...

Stock alternators put out a whopping 60 amps. If you want the dip in voltage to go away you'll need to do a 3G upgrade. They come in 110 and 130 amps.
10-22-2013, 12:34 AM
Replies: 4
Views: 970
Posted By mattdel

Next time it happens, wiggle the key a bit and...

Next time it happens, wiggle the key a bit and give the underside of the column a whack or two. If it changes, ignition switch.
10-22-2013, 12:33 AM
Replies: 1
Views: 361
Posted By mattdel

Undo the tank straps and let it drop a few inches...

Undo the tank straps and let it drop a few inches while pushing it towards the driver side. The filler hose goes into the grommet a good 4 inches.
07-27-2013, 10:13 PM
Replies: 21
Views: 1,172
Posted By mattdel

Be willing to bet they're internal to the oil...

Be willing to bet they're internal to the oil pump.
07-27-2013, 11:06 AM
Replies: 5
Views: 449
Posted By mattdel

Sounds like maybe a bad coolant temp sensor. The...

Sounds like maybe a bad coolant temp sensor. The engine adjusts fuel curves based on the temp readings it provides.
07-26-2013, 05:38 PM
Replies: 91
Views: 9,750
Posted By mattdel

No the foil is a radio wave shield for the...

No the foil is a radio wave shield for the tach/coil and TFI signal. I'll revisit this thread in a few hours, I'm a little drunk right now. We'll figure out where the short is.
07-24-2013, 02:40 PM
Replies: 2
Views: 313
Posted By mattdel

Likely a coincidence. When the motors get tired,...

Likely a coincidence. When the motors get tired, they won't go up anymore. They will still go down though.
07-24-2013, 01:19 PM
Replies: 91
Views: 9,750
Posted By mattdel

Start checking the harnesses that pass through...

Start checking the harnesses that pass through steel. You have a short to ground either near the battery or near the computer.
07-24-2013, 01:11 PM
Replies: 14
Views: 3,681
Posted By mattdel

A proper scanner is capable of doing those tests...

A proper scanner is capable of doing those tests and reporting the results back to you. A real, shop scanner. Not an autozone scanner.
07-19-2013, 03:13 PM
Replies: 23
Views: 3,671
Posted By mattdel

Pressure is a ****ty alternative for volume. Who...

Pressure is a ****ty alternative for volume. Who taught you to tune? Get your money back.
07-15-2013, 05:21 PM
Replies: 91
Views: 9,750
Posted By mattdel

That's an EGR misfire. Probably a bit lean, given...

That's an EGR misfire. Probably a bit lean, given your conundrum with the inj/maf combo.
07-15-2013, 05:19 PM
Replies: 22
Views: 941
Posted By mattdel

Then your description is faulty. Each piece of...

Then your description is faulty. Each piece of the cooling system has it's own individual symptoms when they fail. Properly describing the way your car overheats is the only way to get help online....
07-15-2013, 02:37 PM
Replies: 22
Views: 941
Posted By mattdel

If the temp immediately comes back down after...

If the temp immediately comes back down after you're not "on it" anymore, its flow related.
07-14-2013, 08:35 PM
Replies: 5
Views: 662
Posted By mattdel

255/24#, mayyybe 30.

255/24#, mayyybe 30.
07-14-2013, 07:43 PM
Replies: 22
Views: 941
Posted By mattdel

possibly the radiator is a bit cloggy. fan...

possibly the radiator is a bit cloggy. fan working?
07-13-2013, 01:19 PM
Replies: 14
Views: 1,221
Posted By mattdel

Just contact the ones who have TB's and ask them...

Just contact the ones who have TB's and ask them about the cable.
07-13-2013, 12:24 PM
Replies: 14
Views: 1,221
Posted By mattdel

Or, you can use www.car-part.com and go through...

Or, you can use www.car-part.com and go through the hundreds of SN95's in the junkyards across the US.
Showing results 1 to 25 of 499
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.