iceguyb14

Took the car out to the 1/4 mile to see what it can do. Used my updated tune from Lund Racing (the one before this only made 378whp with the JLT intake and tune) and this was the best of the night (only able to make 2 runs).

[YOUTUBE]lwPNDcTVD-4[/YOUTUBE]



It was a good clean run and I had a good launch on the stock tires and the time isn't too bad, but the MPH just doesn't seem to be there. I mean would expect that mph stock. With intake and tune I'd expect 114+ easily and with that 60' around 12.2s-12.3s. Any ideas? The DA the time of this run was approximately 200' which shouldn't affect the mph at all.

Stone629

Solid ETs and 60', but I agree that MPH is way down. What RPM is your car at crossing the 1/4?

iceguyb14

Thanks. And I have no idea. It's towards the top of 4th. Probably around 6800.

REDBOSS1

Don't know about the mph but 12.4 on the stock tires is outstanding.

z28th1s

Good ET, but I agree the trap should have been higher.

iceguyb14

thanks guys. yeah im pretty happy with the ET but the trap is all that im not happy about. the ET i'm sure i could have gotten down some too if i had some time. that was the first run i made and it was early in the night. but there were so many bikes (over 100) and people kept braking, it took forever to get runs done so i just made 2 runs.

Mishri

I've noticed from reading on forums that people with lund tunes are typically running slower than those with other tunes. Although I'm considering switching to a lund tune because I want a good safe tune, not too sure about my BBR tune, I keep getting a p050e code since i started running it, they say to just clear it means nothing, but i dunno... I think i'll do a lund or bama tune.