restoring stock height
 

Hello Mustang People,

I a little bit of a mustang newbie.

I just purchased a 2010 Mustang GT. I'm the third owner. the original owner did a lot of mods to the car. I can see a upgraded cold air intake, throttle body, exhaust, racing clutch. etc.

my question:

The car has 19s, it's been lowered what appears to be almost 3 inches the front and rear tires are inside the fender lip. I need to raise this car back up to stock height.

So I need some guidance, I called the my local ford dealer for parts the stock springs are discounted and the available stock will cost over $450. I have found various aftermarket stock height springs on eBay.

But I don't know what to buy and I'm not sure if other mods where done to get the car so low.

I need a Mustang Big Brother to help me.

thanks all

Lowered, usually means replacing the springs will put it back to stock height.

Just get the OEM springs for that year off eBay.

For front, buy a Quick Strut kit, and replace both sides, it's easier, and cheaper.