Launching s/c cobras
#11
RE: Launching s/c cobras
ORIGINAL: satisfyingly_purple
I was considering doing the gt axle like freewilly said but started to question it after I bought this months mustang magazine that was comparing the terminators to the new shelby gt500. The article praised 03/04 cobras up and down but noted the problems with irs. The professionals made a good point that it may be prudent to go with a solid axle if you're keeping it on the drag strip, but for street driving and taking turns the irs handles like no other.
/shrug. I can tell that launching is going to take a bit of talent and a lot of practice. I will give it time and keep doing some small mods for now.
I was considering doing the gt axle like freewilly said but started to question it after I bought this months mustang magazine that was comparing the terminators to the new shelby gt500. The article praised 03/04 cobras up and down but noted the problems with irs. The professionals made a good point that it may be prudent to go with a solid axle if you're keeping it on the drag strip, but for street driving and taking turns the irs handles like no other.
/shrug. I can tell that launching is going to take a bit of talent and a lot of practice. I will give it time and keep doing some small mods for now.
Thread
Thread Starter
Forum
Replies
Last Post
MustangForums Editor
Mustang News, Concepts, Rumors & Discussion
3
11-10-2015 11:39 AM
Daddys Girls GTs
5.0L (1979-1995) Mustang
3
09-14-2015 08:46 PM