Dyno results -VMP TVS Supercharger
07-19-2013, 11:57 AM
#11
SVT Section Moderator
Thread Starter
Join Date: Jul 2008
Location: Burnt Hills, NY
Posts: 15,601
.... if that helps! 
07-19-2013, 12:37 PM
#13
SVT Section Moderator
Thread Starter
Join Date: Jul 2008
Location: Burnt Hills, NY
Posts: 15,601
..... Next is a 26 spline input shaft with a McLeod RXT clutch .... SRA over the winter! 
07-23-2013, 04:32 PM
#17
SVT Section Moderator
Thread Starter
Join Date: Jul 2008
Location: Burnt Hills, NY
Posts: 15,601
Thanks guys!!!! 
Prior to the addition of the VMP TVS SC, my Cobra made 549 rwhp / 570 rwtq with the POSI Ported Eaton & ran a best of 10.89 at 133.2 mph with a stock IRS & T-56 tranny!! In fact, the next mod will be the 26-spline input shaft along with a McLeod clutch....and I'm looking to build a SRA!!
Prior to the addition of the VMP TVS SC, my Cobra made 549 rwhp / 570 rwtq with the POSI Ported Eaton & ran a best of 10.89 at 133.2 mph with a stock IRS & T-56 tranny!! In fact, the next mod will be the 26-spline input shaft along with a McLeod clutch....and I'm looking to build a SRA!!
07-24-2013, 11:43 AM
#19
SVT Section Moderator
Thread Starter
Join Date: Jul 2008
Location: Burnt Hills, NY
Posts: 15,601
Lol .... pushing this kind of power & torque - even a non-built SRA wouldn't last!!!!
I've been cutting 1.51's with my "stock" IRS with a BF brace .... so they do hold up!! ET Streets (bias ply) really help the stock to the half-shafts!!!
I've been cutting 1.51's with my "stock" IRS with a BF brace .... so they do hold up!! ET Streets (bias ply) really help the stock to the half-shafts!!!
07-28-2013, 12:08 AM
#20
3rd Gear Member
Join Date: Mar 2008
Location: Alpharetta, Ga
Posts: 762