Replacing Ball Joint and Lower Tie Rod
#1
Replacing Ball Joint and Lower Tie Rod
Just purchased a new ball joint and lower tie rod end, to hopefully alleviate some of my car's squeaking and sloppy steering. I know I will need a special tool to take out the ball joint...but how hard is it to replace these?
Also, I will be buying another ball joint/lower tie rod for the other side once I get payed again. Should I just wait and do them both at the same time, or is it alright to do them one at a time?
Also, I will be buying another ball joint/lower tie rod for the other side once I get payed again. Should I just wait and do them both at the same time, or is it alright to do them one at a time?
#3
may -> will. Messing with the tie rods always requires an alignment. You may get it close, but you'll never get it correct. Your tires can wear pretty quickly with an incorrectly alignment. Do both sides at the same time and get it aligned once. Good luck...
Thread
Thread Starter
Forum
Replies
Last Post
Dragonus18
4.6L (1996-2004 Modular) Mustang
8
09-09-2015 01:21 AM